Welch Allyn PROPAQ CS Manual de Serviço descarregar pdf (Página 72)

68 Repair procedures Welch Allyn Propaq CS Vital Signs Monitor

7. Remove the dual battery pack from the Expansion Module.

8. Store the battery in a safe place while disassembling the monitor and Expansion

Module.

When reconnecting the Expansion Module, confirm that the continuous O-ring gasket is

correctly in place.

Removing the dual battery in SpO

module

The steps for removing the battery pack from the SpO

module are similar to the steps

required to remove the battery from the Expansion Module. The monitor is secured to the

SpO

module with four screws with washers.

1. Using a Phillips screwdriver, remove the four screws from the SpO

module rear

panel.

2. Slide the monitor forward until you can disconnect the battery pack cable from the

monitor's power cable.

3. Slide the monitor forward until it can be completely separated from the SpO

module.

4. Remove the dual battery pack.

5. Store the battery in a safe place while disassembling the monitor and SpO

module.

When attaching the SpO

module, verify that the continuous O-ring gasket is in place.

Opening the monitor

Follow these steps to open the monitor casing and gain access to the three removable

monitor boards and display. (You do not need to remove the handle to remove the boards.)

1. Remove the battery pack (“Removing the single battery pack” on page 66).

2. Using a Phillips screwdriver, remove the six screws securing the Rear Chassis to the

Interface Chassis.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 141 142

Sem comentários

Welch Allyn PROPAQ CS Manual de Serviço Página 72